What got done:

• Soldered on the chokes and finished the capacitor board
• Formed the work coil and soldered it to the board
• Connected the power supply to a switch and connected it to the driver circuit
• Connected an LED to show when the circuit has power
• Did initial testing with iron, achieving roughly 1000  degrees Fahrenheit in a short period of time

Issues:

• A power supply wire pulled away from the copper clad board, meaning we had to move our circuit around a little and re-solder for sturdier connection
• Our work coil reaches very high temperatures, especially with object being heated.
• Capacitor bank gets hot with prolonged use

Next steps:

• Part-Sim theoretical testing
• Possible future testing with varied capacitance

                          Bottom of the circuit

      Top-down view of circuit