Quantity | Component name | |
1 | × | Arduino Pro Micro with male header |
6 | × | 6x6x5 mm tactile Button with button Cap actually any 6x6 tactile button will do, but this one I recommend for the model that I build |
1 | × | 0.96 Inch 7 Pin SPI Oled module o not use the I2C Oled, because it is incompatible with the arduboy platform |
1 | × | 5v small circle Buzzer |
1 | × | 3 Pin slide switch |
1 | × | solder |
1 | × | soldering iron |
1 | × | flux |
1 | × | third hand or bit vise optional |
1 | × | 3.7 volt Lipo Battery actually You can use various kind of battery as long as the Pro Micro capable of |