Raspberry Pi Zero Prism

Back to overview

Pi Zero Prism is the upgraded version of Pi Zero Smart glass.Uses Image,Facial,ocr recognition,and browse Internet on it.

Ricardo Ferro

1

Step 1

here we have the Kopin 922k, we will extract the lcd module only.
2

Step 2

Unscrew the case the holds the microlcd
3

Step 3

Becareful not to damage the ribbon cable connected to the microLCD
4

Step 4

place a little piece of tape over the screen to prevent fingerprint smudges
5

Step 5

remove the white backplate
6

Step 6

Remove the red/black wires from the led.Place tape over the light dispersal films.
7

Step 7

Wew are going to trim the white sides circled in red
8

Step 8

Now that the white sides are trimmed it should be easier to insert into the Frontpiece.STL
9

Step 9

i will break it down to 3 parts Front Bridge(left),Button Bridge(Middle),Pi holder(right). Its easier to start assembling/wiring the Button Bridge first, then the pi holder and finally the front bridge.
10

Step 10

Button Bridge
Cut 30AWG x6 100mm strands and wire to 3x SMD tactile buttons.Assemble inside Button Bridge

Discussions

Frank Turscak wrote 12/01/2018 at 05:52

Very interesting. My wife is blind with macular degeneration (AMD). Been looking at Google glass and VR. Don't know if I could help in any way.

Are you sure? yes | no