Cut one of each of the following files.

- kellycaster_back.DXF

- kellycaster_middle.DXF

- kellycaster_top.DXF

Glue the top of the body to the middle of the body.

Protip: Using the neck to line two pieces up is a good idea.

Glue the back of the body on, this is made easier using a large clamp with one side on the neck pocket for alignment.

Sand the sides of the body with increasing grits of sandpaper, until you're satisfied.

Apply your sanding sealer and finish.

Bolt on your neck, with the tuners installed.

Wire the electronics in whatever interesting configuration you want.

Play your new guitar