1 |
× |
Adafruit Powerboost 1000C
USB boost circuit with integrated charger http://www.ebay.de/itm/282083284436?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
|
1 |
× |
USB Mini breakout board
This breakout is used for my charging input http://www.ebay.de/itm/282073486859?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
|
1 |
× |
Old tetris cartridge
Just an old classic gameboy cartridge which was just used to later on cover up the Raspberry Pi, which sits inside the compartment. (I had this game here already, but I am sure you can find old games very cheap either locally or on eBay)
|
1 |
× |
Tactile switches
These are used for my L1, L2, R1 and R2 buttons, as well as my safe shutdown switch http://www.ebay.de/itm/291371993802?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
|
1 |
× |
3-pin slide switch
This is the main power switch to turn the gameboy on and off http://www.ebay.de/itm/140714113454?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
|
1 |
× |
Leonardo pro micro
This little board is used as my USB gamecontroller which needs to be programmed manually. http://www.ebay.de/itm/301951688967?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
|
1 |
× |
Volume wheel potentiometer
This is used to regulate the audio volume http://www.ebay.de/itm/322281495072?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
|
1 |
× |
64 GB Samsung EVO micro SD card
This is an SD card which has been confirmed to work in a Raspberry Pi, so I took this as my storage http://www.ebay.de/itm/251970254487?_trksid=p2060353.m2749.l2649&var=550837487484&ssPageName=STRK%3AMEBIDX%3AIT
|
1 |
× |
Common Ground DMG+ Control Panel with X, Y, L1 & L2, R1 & R2 from Kitsch-bent
This is a pre-made control panel to make things a little bit easier to install for the front buttons http://www.ebay.de/itm/191968449407?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
|
2 |
× |
Gameboy classic buttons
Original gameboy DMG buttons, because I have additional front buttons (X and Y) in my build, I needed another set of buttons, so I ordered 2 http://www.ebay.de/itm/182258143348?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
|
1 |
× |
Gameboy Speaker
This is a speaker for an Gameboy advance, it is a bit smaller, but it has more beef than the original, so I took this one http://www.ebay.de/itm/181950378790?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
|
2 |
× |
Gameboy classic rubber pad set
This is the conductive rubber pad set which is needed to make have the keypresses made registered, again 2 sets, because of X and Y http://www.ebay.de/itm/181814606804?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
|
1 |
× |
Spare USB port
This is used in the place of the "EXT" port of the original gmaeboy, so I can plug in external devices if I need to http://www.ebay.de/itm/130707477798?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
|
1 |
× |
Headphone jack w/ switch
This is used so you can plug in headphones. The switch is there so it shuts off the amp, and thus the speaker http://www.ebay.de/itm/161337167416?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
|
1 |
× |
Audio amplifier
This amplifier is used for the speaker. It is based on an PAM8403 chip http://www.ebay.de/itm/322283374092?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
|
1 |
× |
3.5" TFT screen w/ controller
This is my main 3.5" screen, you also can get this one from gearbest http://www.ebay.de/itm/162128950289?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
|
1 |
× |
Complete gameboy classic shell
This is an aftermarket case for an original gameboy. I went with the transparent blue http://www.ebay.de/itm/331975728644?_trksid=p2060353.m2749.l2649&var=541023217090&ssPageName=STRK%3AMEBIDX%3AIT
|
1 |
× |
2500 mAh 3.7V battery
This is a phone's battery, but if hooked up correctly, it works as well http://www.ebay.de/itm/391585262102?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
|
2 |
× |
PSP 1000 analog stick
I used analog sticks in my build, because I personaly liked the way of having one "main" stick to walk around for example, and the other as "Control stick", sort of like the Nintedo Gamecube. This sticks can also be gotten from adafruit as far as I know http://www.ebay.de/itm/361351958328?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
|