0%

0%

gustavoriverag

Mechanical engineering student, with interest in computers, mechanical design, digital fabrication and tearing stuff apart :)

Santiago, Chile

Following Follow me

Send a private message

Similar accounts worth following

Send a private message

GitHub

This user joined on 12/21/2022.

My Projects

Implementación de brazo MK2 para recoger objetos en movimiento en una banda transportadora

MKlap2: Pick and place with MK2 arm

Projects I Like & Follow

The 2018 Hackaday Prize

A smaller and cheaper open source brushless motor

PCB Motor

carl-bugeja Carl Bugeja

An Open Source Continuous Inkjet Printer

CIJ Printer

dominik-meffert Dominik Meffert

The 567 tone decoder is perhaps most famous Phase Locked Loop (PLL) chip. This project looks at an Arduino software PLL.

Software Phase Locked Loop

agpcooper agp.cooper

A 3D printed stereotax

3D printed rodent stereotaxic device

lex-kravitz Lex Kravitz

The 2017 Hackaday Prize

No more restrictions from high level software! Access the lowest level of radio transmission with this programmable USB stick.

Open narrowband RF transceiver

A functional 3D printable full body exoskeleton - Passive concept development

3X0 - 3D Printable exoskeleton concept

andrea-piccinno Andrea Piccinno

Two hearts are better than one, so why not have five. Quadcore RPI CM4 and a MCU on a single board for true all-in-one 3D printer control.

Sigmoid S7P 3D Printer Control Board

How I added a 500W heater to my 3D printer to enable reliable ABS printing.

Enclosure Heater for 3D Printer

mark-rehorst Mark Rehorst

Connect all needed electronics to NodeMCU, add life to them with a help of programming, install HomeAssistant on PC and let's roll!

Home Automation With NodeMCU, HomeAssistant & MQTT

A computer built around a Atari 2600 (VCS), with a few nifty upgrades, 6502, 64k + 128bytes ram, coprocessor, 77 is getting a rework

Super atari 6502 (A "DIY" 2600 hardware clone...)

ESP32 runs FabGL to produce VGA display

ESP32 VGA PS/2

land-boardscom land-boards.com

Hackaday Prize 2019

This projects converts a Bobby-Car (children's ride-on toy) to electric by using 4 Hoverboard motors, VESC controllers and an ESP32

Electric Bobby-Car

peter-ptzi Peter Pötzi

A simple pocket-sized projector utilizing an Arduino

DIY Pocket Projector Design

sir-michael-ii Sir Michael II

Fully 3D Printed 6 DOF Arduino Robot Arm

LittleArm Big

Adventures with an Ender 3

How to win at 3D printing

lion-mclionhead lion mclionhead

An open-source dual-channel SDR Raspberry Pi HAT with up to 6 GHz tunable range

CaribouLite SDR for RPI

david-michaeli David Michaeli

Create a monitoring station to measure weather, soil, seismic, solar, magnetic, and gravity conditions - focus best accuracy/dollar w/COTS.

Climate & Environment Monitoring Station

sparksron sparks.ron

Citizen science project with mobile and fixed sensors for measuring air quality using low-cost sensors and smartphones

CanAir.io Air Quality Network

View all

Bits